Moto E32S Screen Replacement Repair Guide
Motorola Moto E32S - Screen Replacement
Tools Required
- Phillips #00 screwdriver
- Plastic opening tool
- Spudger
- Tweezers
- Suction cup
- Heat gun or hairdryer
- SIM card eject tool
Materials Required
- Replacement screen for Motorola Moto E32S
- Adhesive strips or double-sided tape
- Microfiber cloth
Safety Warnings
- Ensure the device is powered off before starting the repair.
- Use caution with sharp tools to avoid injury.
- Be mindful of small parts that can be easily lost during disassembly.
- Avoid excessive heat application to prevent damage to internal components.
- Static electricity can damage electronic components. Use an anti-static wrist strap if possible.
Follow these 9 steps to complete your repair
Power Off and Remove SIM Card
Begin by powering off your Motorola Moto E32S. Once the device is off, use the SIM card eject tool to remove the SIM card tray from the side of the phone.
Heat the Edges of the Screen
Use a heat gun or hairdryer to gently heat the edges of the screen. This will soften the adhesive holding the screen in place. Be careful not to overheat the device.
Pry Open the Screen
Using a suction cup, create a gap between the screen and the frame by pulling gently. Insert a plastic opening tool into the gap and slide it around the edges to separate the screen from the adhesive.
Disconnect the Screen Connector
Carefully lift the screen slightly. Use a spudger to disconnect the screen connector located on the motherboard. This will free the old screen from the device.
Remove the Old Screen
Once the connector is detached, fully remove the old screen from the device. Be gentle to avoid damaging other components.
Prepare the New Screen
Take your new replacement screen and remove any protective films. Clean the screen with a microfiber cloth to eliminate fingerprints and dust.
Attach the New Screen
Connect the new screen to the motherboard using the screen connector. Ensure it is securely attached. Apply adhesive strips or double-sided tape around the frame to secure the new screen.
Secure the Screen
Carefully align the new screen with the device frame and press down gently to secure it in place with the adhesive.
Reinsert SIM Card and Power On
Reinsert the SIM card tray into the device. Finally, power on your Motorola Moto E32S to ensure the new screen is functioning correctly.
