Begin by powering off your Motorola Moto E5 Supra completely. Remove any SIM or SD cards from the device using the SIM card eject tool. This will prevent damage to the cards during the repair process.

Use a plastic opening tool to carefully pry off the back cover of the device. Start at the bottom edge and work your way around the device. Be gentle to avoid damaging the plastic clips holding the cover in place.

Using the Phillips #00 screwdriver, remove the screws securing the battery connector shield. Carefully lift the shield and disconnect the battery connector using a spudger to ensure there's no power running through the device during the repair.

Use a heat gun or hairdryer to apply heat around the edges of the screen to soften the adhesive. Once heated, place a suction cup near the top edge of the screen and gently pull up to create a gap. Insert a plastic opening tool into the gap and slide it around the edges to release the adhesive.

Once the screen is loose, gently lift it but do not fully remove it yet. Locate the display cable connector and use tweezers to disconnect it from the motherboard. Carefully set the old screen aside.

Take the new screen and connect the display cable to the motherboard. Ensure the connection is secure. Align the new screen with the frame and press it into place gently.

Apply double-sided adhesive tape around the edges of the screen for a secure fit. Once aligned correctly, press the screen firmly to ensure the adhesive bonds properly.

Reconnect the battery connector and replace the battery connector shield, securing it with the screws removed earlier.

Align the back cover with the device and press down firmly around the edges to snap it back into place. Ensure all clips are engaged.

Power on the device to ensure the new screen is functioning correctly. Check for display clarity and touch responsiveness. If everything works as expected, the repair is complete.